Sharp AR-FX2 Service Manual page 9

6) Install the Fax key unit.
G Connect the flat cable to the machine connector and fold the flat
cable under the FAX key unit. Fix the Fax key unit with screws.
7) Stick the supplied label.
G After removing the protective sheet from the operation panel, stick
the supplied label to the left of the exposure indicators.
STANDARD
FINE
SUPER FINE
ULTRA FINE
HALF TONE
8) Attach the ground wire.
G Reattach the ground wire to the operation panel with the screw.
Check that the ground wire is securely squeezed by the aluminum
sheets.
9) Attach the operation panel of the copier machine.
G Attach the flat cable and fix with a screw.
Note: Before attaching the flat cable, release the connector lock and
insert the cable. After attachment, lock the connector.
M3 8
M3 8
Blue line-must be up
AUOT
MANUAL
PHOTO
Blue line-must be up
M3 8
10) Attach the front cover to the copier.
G Warp the front cover by pressing the both sides, and attach it to the
hinge arm of the machine. After attaching the paper tray, close the
side cover and the bypass tray.
11) Remove the rear cabinet of the machine.
G Remove the document cover. Remove the screw and remove the
rear cabinet.
12) Remove the shield plate of the copier.
G Remove the screw.
13) Attach the PWB mounting frame.
G If a ground plate is present, remove it and attach the PWB mounting
frame by aligning the two positioning locators and using the supplied
M3 screws (silver color) as shown in the illustration.
Note: Check that the AC cord is passed under the projection (#) as
shown in the figure. If not, loosen the AC cord holder screws,
and pass it under the projection, then tighten two screws.
Ground plate
Positioning locators
3 – 2
AR-FX2
If an open/close detector
is present, take care not
to break the actuator.