Sharp AR-FX2 Service Manual page 27

SW Data
Item
NO. NO.
SW19 3 Output only in
case of
protocol
monitor error
4 Reserved
5 Reserved
6 Reserved
7 Time
designation 1
of
communication
record table
8 Time
designation 2
of
communication
record table
SW20 1 Line sound
monitor range
2
3 Line monitor
display
4 Operation
panel key
sound
5 Receivable
memory
capacity left
6 Memory over
during reception
7 Reserved
8 Reserved
Switch selection and contents of functions
Effective only when SW19-1 is set to 1 (YES). Used to
set whether protocol monitor is outputted only when a
communication is not completed normally due to a
communication error or it is outputted after completion of
every communication.
0: After completion of
1: Only in case of an
every communication (All
error
output)
Used to set whether the communication record table is
printed at the designated time 1 or not.
1: Enable 0: Disable
Used to set whether the communication record table is
printed at the designated time 2 or not.
1: Enable 0: Disable
Used to set the line sound monitor range when the line
monitor function is used.
When set to "Until NSF signal send/receive", monitoring
is made until the NSF signal is sent or received. When
set to "All", monitoring is made for all until the line is
disconnected.
SW20 Bit No.
OFF
Until NSF signal send/receive
All
Used to set whether the communication speed and the
reception level are displayed on the LCD or not.
1: YES 0: NO
Used to set whether the key click sound of FAX related
keys are made or not when operating in the FAX mode.
1: Not ring 0: Ring
Used to set the remaining memory capacity for
acceptance of call. (This is not the memory judgement
level during reception.)
1: 64Kbyte 0: 128Kbyte
Used to set whether the received data are outputted or
destroyed when memory is over during reception.
1: Output 0: Not output
Initial value
NO
Disable
Disable
OFF
1 2
0 0
0 1
1 0
NO
Ring
128 Kbyte
Output
6 – 9
AR-FX2
User
program Remark
No.
0
0
0
0
0 139
0 139
0 When set to
"11", set to "00".
0
0
0
0
1
0
0