Chapter 10 Wj-Pn Specification - Hitachi WJ200 Series Quick Reference Manual

Chapter 10 WJ-PN Specification

10.1 WJ-PN Specifications
Unit type
Model
Installation
Dimensions (W x H x D)
Weight
Ambient
temperature
Ambient operating humidity
Storage temperature
Vibration resistance
Environment
Dielectric strength
Conformance to EMC and
electrical safety standards
Enclosure rating
Communications protocol
Device type
Conformance class
Protocol
Netload
RT / IRT
Profile
PROFINET
Interface
Physical layer
port
Connector
MAC address
Cable
Communications distance
Version
Application class
Telegram
PROFIdrive
Configuring of telegram
Operating mode
Jogging
Note1: When WJ-PN is attached to WJ200 / WL200, functional safety is not supported. Please refer
to "5.3 A system configuration of the PROFINET" for details.
Note2: C1 only when installed in a metal cabinet, otherwise C2.
Item
operating
Specification
WJ200 / WL200 Series Option Board
WJ-PN
68 x 60 x 45[mm]
170[g] (typical)
-10 to 50[degree] (no icing or condensation)
20 to 90[%], RH
-20 to 65°C (no icing or condensation)
2
5.9[m/s ] (0.6[G]) at 10 to 55[Hz]
500[V ] (between isolated circuits)
AC
EN61800-3: 2004 / A1:2012 (2014/30/EU) First
environment, Category C1
EN61800-5-1: 2007 (2014/35/EU)
IP 20
PROFINET IO Ver2.32
PROFINET IO Device
B
DCP, LLDP, SNMP
I
only RT
PROFIdrive
Auto negotiation
(100BASE-TX (IEEE802.3) only)
2 ports
RJ45 (Port1 / 2)
3 (Host, Port 1 / 2)
100BX-TX supported (category 5e or higher)
STP cable (straight or cross allowed)
Distance between nodes: 100[m] max
4.2
AC1 (Standard Drive)
Standard telegram 1
WJ-PN telegram 103 (same as PPO3 of PROFIdrive
version 2)
WJ-PN telegram 104 (same as PPO4 of PROFIdrive
version 2)
WJ-PN telegram 105 (like PPO5 of PROFIdrive
version 2)
From P160 to P179 of WJ200 / WL200 parameters
Speed control mode
Only jogging 1 is supported.
62
*1
*2