Siemens SINUMERIK 828D Function Manual page 963

PI service: TMRASS
Function: Reset active status
Resetting the active status on worn tools
This PI service is used to search for all tools with the tool status active and disabled. The active status is then
canceled for these tools. Potentially appropriate times for this PI service are the negative edge of VDI signal "tool
disable ineffective", an end of program, or a channel RESET. This PI service is intended mainly for the PLC,
since it knows when the disabled tool is finally no longer to be used.
Parameterization
Signal Type Value range
PIService ANY PI. TMRASS
Unit INT 1 ... 10
PI service: TRESMO
Function: Reset monitoring values
This PI service resets the monitoring values of the designated edges of the designated tools to their setpoint
(initial) values.
This only relates to tools with active monitoring.
Compare the NC-Speech Command RESETMON.
Parameterization
Signal Type Value range
PIService ANY PI. TRESMO
Unit INT 1 ... 10
WVar1 WORD - max ... max
WVar2 WORD 0 ... max.
WVar3 WORD 0 ...15
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Meaning
Reset active status
TO area
Meaning
Reset monitoring values
TO area
ToolNumber
0: Applies to all tools
> 0: Applies only to this tool
< 0: Applies to all sister tools of the specified T No.
D number
< 0: Monitoring of specified edge of specified tools is
reset.
0: Monitoring of all edges of specified tools is reset.
Monitoring types
Type of monitoring to be reset.
This parameter is binary-coded.
1: Tool-life monitoring is reset.
2: Count monitoring is reset.
4: Wear monitoring is reset.
8: Sum-offset monitoring is reset.
Combinations of monitoring types can be reset by
adding the values above.
0: All active tool-monitoring functions ($TC_TP9) are
reset.
P3: Basic PLC Program for SINUMERIK 840D sl
13.13 Block descriptions
963