Siemens SINUMERIK 828D Function Manual page 675

Number Identifier: $MC_
20230 CUTCOM_CURVE_INSERT_LIMIT
20240 CUTCOM_MAXNUM_CHECK_BLOCKS
20250 CUTCOM_MAXNUM_DUMMY_BLOCKS
20270 CUTTING_EDGE_DEFAULT
20400 LOOKAH_USE_VELO_NEXT_BLOCK
20430 LOOKAH_NUM_OVR_POINTS
20440 LOOKAH_OVR_POINTS
20500 CONST_VELO_MIN_TIME
20600 MAX_PATH_JERK
20610 ADD_MOVE_ACCEL_RESERVE
20700 REFP_NC_START_LOCK
20750 ALLOW_GO_IN_G96
20800 SPF_END_TO_VDI
21000 CIRCLE_ERROR_CONST
21010 CIRCLE_ERROR_FACTOR
21100 ORIENTATION_IS_EULER
21110 X_AXIS_IN_OLD_X_Z_PLANE
21200 LIFTFAST_DIST
21210 SETINT_ASSIGN_FASTIN
21202 LIFTFAST_WITH_MIRROR
Block search
Number Identifier: $MC_
20128 COLLECT_TOOL_CHANGE
22600 SERUPRO_SPEED_MODE
22601 SERUPRO_SPEED_FACTOR
22621 ENABLE_START_MODE_MASK_PRT
22622 DISABLE_PLC_START
22680 AUTO_IPTR_LOCK
Reset response
Number Identifier: $MC_
20110 RESET_MODE_MASK
20112 START_MODE_MASK
20118 GEOAX_CHANGE_RESET
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
K1: Mode group, channel, program operation, reset response
Description
Maximum angle for intersection calculation with tool
radius compensation
Blocks for predictive contour calculation with tool
radius compensation
Maximum number of blocks without traversing motion
for TRC
Basic setting of tool cutting edge without programming
Look Ahead to programmed following block velocity
Number of override corner values for Look Ahead
Override switch points for LookAhead
Minimum time with constant velocity
Path­related maximum jerk
Acceleration reserve for overlaid movements
NC start disable without reference point
G0 logic for G96, G961
Subprogram end to PLC
Circle end point monitoring constant
Circle end point monitoring factor
Angle definition for orientation programming
Coordinate system for automatic Frame definition
Traversing path for fast retraction from the contour
HW assignment of the ext. NCK input byte for NC
program interrupt:
Lift fast with mirror
Description
Tool change commands to the PLC after block search
Velocity with block search type 5
Velocity factor for block search type 5
Switches MD22620: START_MODE_MASK_ PRT for
SERUPRO search run
Allow part program start via PLC
Disable interrupt pointer
Description
Initial setting after RESET / parts program end
Basic setting for NC start after part program start
Allow automatic geometry axis change
9.17 Data lists
675