Adjustment - Toshiba e-STUDIO163 Service Handbook

3.

ADJUSTMENT

3.1 Adjustment of Auto-Toner Sensor
When the developer material is replaced, adjust the auto-toner sensor in the following procedure.
<Procedure> (Adjustment Mode (05-200))
(1) Install the process unit into the equipment.
Note: Note:
Do not install the toner cartridge.
(2) While pressing [0] and [5] simultaneously, turn the power ON.
The following message will be displayed.
(3) Key in code [200] and press the [START] button.
The display changes as follows.
Notes:
• A indicates the controlled value of the auto-toner sensor output. Press the Up or Down button
to change the value.
• B indicates the output voltage of the auto-toner sensor (2.30 V in the above case).
The drum, developer unit, etc. are in operation.
• C indicates the latest adjustment value.
December 2005 © TOSHIBA TEC
T .B.D
Fig. 3-1
T .B.D
Fig. 3-2
3 - 1
e-STUDIO163/203 ADJUSTMENT
3