Panasonic KX-NS1000 Pc Programming Manual page 795

Call Transfer Sequence (Other)
Specifies the Call Transfer Sequence used by the mailbox. Only specified if
(Selection) is set to "Other".
Value Range
Enter a maximum of 16 characters consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
Feature Guide References
3.2.2.8 Call Transfer Status
No Answer Time (Selection/Other)
Specifies the length of time that the Unified Messaging system waits before handling unanswered calls to the
extension.
Note
When "System" is selected, the Unified Messaging system uses the time pre-programmed in 24.4 UM
Configuration—[5-4] System Parameters—Parameters—Dialling Parameters/MSW Notification—
Dialling Parameters—Call Transfer No Answer Time (10-60 s).
Value Range
System, Other (If "Other" is selected, specify 10–60 s)
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
PC Programming Manual References
24.4 UM Configuration—[5-4] System Parameters—Parameters—Dialling Parameters/MSW Notification—
Dialling Parameters—Call Transfer No Answer Time (10-60 s)
Call Transfer Status
Determines how the Unified Messaging system handles a call when it reaches the subscriber's extension. Click
Edit for the extension to change, programme the settings, and click OK to finish.
Note
This setting can be changed by subscribers.
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
, # and special codes:
Call Transfer Sequence
PC Programming Manual 795