Change The Hmi, Disconnect/Connect The Main Power Cables And The Control Cables - ABB PSTX370 Service Manual

3.3 Change the HMI, Disconnect/
Connect the main power cables
and the control cables
This chapter describes how to change the HMI,
disconnect or connect the main power cables and
the control cables prior to performing service on the
softstarter.
WARNING. HAZARDOUS VOLTAGE
Always make sure that the power supply is
switched off before doing maintenance on the
Softstarter.
WARNING
When performing maintenance on the Softstarter,
an antistatic strap must be used. The antistatic
strap should be worn on the wrist, and be
connected to an electrical ground, to prevent
electrostatic discharge (ESD) damage to the
Softstarter.
WARNING
The life span of electronics can be affected by
damage caused by electrostatic discharge. This
can happen if a charged tool or person touches a
component. Therefore it is very important that all
tools and personnel are discharged by touching
an earthed point before the PCBA or any of the
components are touched. It is equally important to
discharge the package with the new component
before opening it.
A person walking on a carpet can be charged with
up to fifteen thousand volt (15000V). Compare
this with the fact that some sensitive components
can be destroyed when discharged on a much
lower level (about 100V). We kindly ask you to pay
notice to this, as this is a vital point in order to
ensure the life span and function of the product.
Tools required:
• Slotted screwdriver for removing the HMI
• Slotted screwdriver M3 for removing the control cables
• Hexagon screwdriver no. 8 for removing the main
power cables
| Service Manual | Service PSTX210...370
1SFC13105M0201
3
21