Siemens SINAMICS S120 Installation And Start-Up Manual page 233

Copying a drive data set
Set parameter p0819 as follows:
1. p0819[0] = Number of the drive data set to be copied (source)
2. p0819[1] = Number of the drive data set to which the data is to be copied
3. p0819[2] = 1
Start copying.
Copying is finished when p0819[2] = 0.
Note
In STARTER, you can set the drive data sets via the drive configuration.
Function diagram overview (see List Manual)
S 8565
S 8570
Parameter overview (see List Manual)
Variable parameters
S p0120
S p0130
S p0140
S p0170
S p0180
S p0170
S p0810
S p0811
S p0812
S p0813
S p0819[0...2]
E Siemens AG, 2004. All rights reserved
SINAMICS S120 Installation and Start-Up Manual, 12/04 Edition
(target)
Drive Data Sets (DDS)
Encoder Data Sets (EDS)
Power Module data set (PDS) number
Motor data set (MDS) number
Encoder data set (EDS) number
Command data set (CDS) number
Drive data set (DDS) number
Copy command data set CDS
BI: Command data set selection CDS bit 0
BI: Command data set selection CDS bit 1
BI: Command data set selection CDS bit 2
BI: Command data set selection CDS bit 3
Copy drive data set (DDS)
Basic Information about the Drive System
Data sets
7-233