Mitsubishi Electric QD77MS User Manual page 102

[Cd.609] Cam auto-generation cam No.
Set the cam No. to be generated automatically.
[Cd.610] Cam auto-generation type
Set the type of cam auto-generation.
[Cd.611] Cam auto-generation data
Set the cam auto-generation data corresponding to "[Cd.610] Cam auto-generation type".
1) For a rotary cutter
The cam data starting point for a rotary cutter is 0.
Buffer memory
address
53204 Cam resolution
53206
Sheet length
53207
Sheet
53208
synchronization
53209
width
53210 Synchronous axis
53211 length
53212 Synchronization
53213 starting point
Synchronous
53214 section acceleration
ratio
Item Setting value
256/512/1024/2048/
4096/8192/16384/32768
1 to 2147483647
[(Optional) Same unit
(0.1mm, etc.)]
1 to 2147483647
[(Optional) Same unit
(0.1mm, etc.)]
1 to 2147483647
[(Optional) Same unit
(0.1mm, etc.)]
0 to 2147483647
[(Optional) Same unit
(0.1mm, etc.)]
-5000 to 5000 [0.01%]
3 - 18
Chapter 3 Cam Function
Details
Set the cam resolution for generating the
cam.
Set the sheet length.
Set this value in the cam axis length per
cycle.
Set the sheet length of the synchronous
section.
Set the cycle length of the rotary cutter
shaft.
Set the length from the beginning of the
sheet to the start of the synchronous
section.
Set when the synchronous speed in the
synchronous section needs to be adjusted.
The speed is "Synchronous speed
(100% + Acceleration ratio)" in the
synchronous section.