8.3.3.
Exit Roller
(1) Remove the Front Cover. (See 8.2.4.)
(2) Remove the screw (a) and the Tension-plate Assembly
with the spring. And remove the 2 screws (b) and the
Side-plate Assembly.
(3) Remove the Conveyor Belt from the Exit Roller.
Reassembling Note: Tension-plate Assembly
See 8.3.1.
(4) Pull and remove the Pulley of the Exit Roller in the
direction of the arrow while unlocking the stopper on the
pulley.
Reassembling Note:
After reassembling the Pulley, be sure to check
the Pulley's lock to the Exit Roller by pulling the
pulley.
(including BELT LAYOUT)
47