Panasonic KV-S1025C SERIES Service Manual page 51

8.3.6. Lamp (F)
(1) Remove the Optical Unit (F). (See 8.3.5.)
(2) Disconnect the connector from the Lamp Drive Board (F).
(3) Remove the 2 screws.
(4) Pull out the Cable 1 in the direction of the arrow (1),
and then pull out the Cable 2 in the direction of the
arrow (2), so that the Lamp Holder (F) can be held
upwards easily.
(5) Slide Lamp Holder (F) slightly in the direction of the
arrow (3), and lift the holder.
(6) Unhook the wires, and remove the Lamp (F).
Reassembling Note:
When attaching the Lamp Holder (F) to the scanner,
insert the hooks of the holder to the holes and slide
them in the direction of the arrows until they stop.
51