Service Utility Function - Panasonic KV-S1025C SERIES Service Manual

9.2.

Service Utility Function

The Service Utility function is as follows.
Note:
When two or more scanners are connected to the PC, execute "Select Scanner" to define the scanner before evaluating.
The procedure is as follows.
1. Click "Select Scanner" on the Main Menu.
2. Select the product number of the scanner to evaluate.
Item
*1
Scanner Status
*1
Scanner Information
Scanner Counter
Update All Counters
Clear Counter
(After Clean Roller)
Clear Counter
(After Replace
"Double-feed
Prevention Roller")
Clear Counter
(After Replace "Paper
Feed Roller")
Scanner Condition
Sleep Mode
Vertical Line
Reduction
Warning Setting
Set Default
Test LED
Key / Sensor
Conveyor Motor
Feed
Sleep Mode
CCD Level
Memory
Adjust Shading
All Position
Individual Position
USB ID
Other
Save Information
Note:
*1
: These items are included in User Utility software.
*2
: This setting is needed when replacing CONTROL Board or IC1011.
*3
: Available only for KV-S1025C Series
Remarks
(1) Parameter setting by user
(2) Status indication
(3) Parameter setting by service person
(4) Adjustment
(5) Diagnosis
(6) Maintenance
Used to indicate the scanner status (Ready, Error, or Warning)
Used to indicate the scanner information, such as Model, Firmware Version,
Interface, and etc.
Used to update the values of System Counter, Cleaning Roller Counter, and
*1
Replacing Roller Counter
Used to reset the Cleaning Roller Counter to zero after cleaning the roller
*1
Used to reset the counter (After Replace "Double-feed Prevention Roller") to
*1
zero
*1 Used to reset the counter (After Replace "Paper Feed Roller") to zero
Used to set this setting to "Enable" or "Disable", and to set "Waiting Time"
*1
before entering the Sleep Mode
Used to reduce vertical lines on the scanned image caused by a scratch or
dust in the scanning area
*1
*1 Used to set the number of document scanning that enables the Service Utility
to inform the warning messages (roller replacement timing and roller
cleaning timing)
Used to set the "Sleep Mode" and "Warning Setting" to the default settings
Used to test the LEDs (Green, Red) on the front panel by turning on/off
periodically
Used to perform the Key or Sensor ON/OFF test
Used to check Conveyor Motor Rotation
Used to check the paper feed mechanism
Used to check whether sleep mode function works properly
Used to check a maximum peak level after setting CCD gain
Used to execute memory R/W test
Used to execute shading correction
Used to adjust the scanning length, width, paper-end, vertical, and horizontal
positions for front
1. Used to execute automatic length, width, paper-end, vertical, or horizontal
position adjustment for front (and back)
2. Used to adjust scanning length, width, paper-end, vertical, or horizontal
positions for front (and back)
*2 Used to set a USB ID for the scanner connected to the PC
Used to save the scanner and PC information
*1
Purpose
*3
(and back) sides, automatically
*3
sides, individually
*3
sides manually
64
Remarks
(2)
(2)
(1), (6)
(1), (6)
(1), (6)
(1), (6)
(1)
(4)
(3)
(3)
(5)
(5)
(5)
(5)
(5)
(5)
(5)
(4)
(4)
(4)
(4)
(1)