Panasonic KV-S1025C SERIES Service Manual page 68

9.3.5. Scanner Condition
Item
Sleep Mode 1. Click "Sleep Mode" on the main menu.
2. Enable or Disable "Sleep Mode" by checking the
appropriate check-box.
3. Set "Waiting time" (Unit: minutes), that means set-up time
until the scanner enters the sleep mode.
4. Click "OK" to renew the setting.
Vertical Line 1. Click "Vertical Line Reduction" on the main menu.
Reduction 2. Push "Start Vertical Line Reduction" on "Vertical Line
Reduction" dialog box.
Note:
a. When selecting "Restore Default", the factory-setting
b. The following procedures "3rd" or more are available
3. Clean the conveyors, rollers, and scanning area (glass,
reference area) according to the message on the display, and
then click "OK".
4. Set the 3 sheets of clean white paper (size: Letter or A4) on
the Feed Tray in the portrait orientation, and then click "OK"
to start this execution.
5. Confirm the result. And then click "OK".
6. Click "Close" to get back to the main menu.
Warning Setting 1. Click "Warning Setting" on the main menu.
2. Change the parameter value on "Warning Setting" dialog
box.
3. Click "OK" to apply the setting.
Set Default 1. Click "Set Default" on the main menu.
2. Click "Set Default" on "Set Default" dialog box to set the
"Sleep Mode", "Clean Roller Timing", "Replace
Double-feed Prevention Roller Timing", and "Replace
Paper Feed Roller Timing" to the default settings
3. Click "Close" to get back to the main menu.
Operation
data will be overwritten instead of the current
shading data.
only for selecting "Start Vertical Line Reduction"
Default
Enable
15 minutes
Clean:2000
Replace:
See
"Remarks".
.
68
Remarks
—
Until this process is completed,
do not stop the process, and do
not open the ADF door.
(Default)
Double-Feed Prevention Roller:
→ 50,000
Paper Feed Roller:
→ 100,000
—