Remote Kvm Console Operation; Ipv6 Protocol Support - HP 16-port SCS Installation Instructions Manual

Remote KVM console operation

A PC or workstation can function as a remote (in-band) KVM console by connecting to the HP IP
Console Switch through a network interface. An IT administrator can use a workstation as a KVM
console to access and manage the servers in the data center.
There are a number of considerations when implementing remote KVM consoling:
x Network protocol
x Network performance
x Type of session
x User management

IPv6 protocol support

The latest versions of the HP console switches support IPv4 and IPv6 protocols with the onboard IP
Console Viewer, the OSD (Figure 8), and the serial console configuration software. The significantly
higher addressing capability of IPv6 relieves the address exhaustion and translation issues that are
inherent with IPv4.
Figure 8. OSD network settings menu
A. Network settings menu, IPv4 selected B. Network settings menu, IPv6 selected
Only one protocol (IPv4 or IPv6) can be configured for a KVM system. The IPv4 protocol is the
default, and it can be set for either Static or BOOTP (default) addressing. Operation with IPv4 allows
switch firmware updates from File Transfer Protocol (FTP) or Trivial FTP (TFTP) servers.
The IPv6 protocol can be set to either Static or DHCPv6 addressing. Note that IPv6 supports firmware
updates using only the FTP method when doing the update from the OSD or Serial management
interface. Firmware updates can also be done on an IP Console Switch using the remote management
interface.