HP 16-port SCS Installation Instructions Manual page 67

Table 5-14 Server CLI command parameters
Parameter
TIMEOUT=<time-out>
Server FLASH
The Server FLASH command updates the SCS program images in FLASH memory. You might want to use this
command to update the program with new features or to install a later release of the program.
There are two program images that you must update in the SCS FLASH. The boot image file (SCS50bt.img) contains
the SCS startup and self-test logic. The application image (SCS50app.img) contains the program that provides SCS
functionality.
You will need a TFTP server. Download the latest FLASH image from the HP website and save the image file to the
appropriate directory on the TFTP server.
Powering down a system in the middle of a boot FLASH update might render the unit inoperable. To update the
bootstrap, HP recommends that the unit be placed on a UPS under controlled conditions to avoid interruption of the
boot FLASH update process.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server flash boot|app hostip=<tftp_add> image=<host_file>
Table 5-15 Server FLASH command parameters
Parameter
BOOT|APP
HOSTIP=<tftp_add>
IMAGE=<host_file>
Example
The following command updates the boot image program using the image file name
c:\winnt\system32\drivers\SCS50bt.img, which is located on the TFTP server host located at 192.168.1.16.
> ser fla boo hostip=192.168.1.16 c:\winnt\system32\drivers\ima=SCS50bt.img
Server Init
The Server Init command reinitializes the SCS configuration database, that is, restores it to default values. You
can choose to retain only the network address information.
When you enter this command, you are prompted to confirm or cancel the reinitialization.
You can also reinitialize the SCS in hardware. See "Reinitializing."
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server init config|all
Table 5-16
Server Init command parameters
Parameter
CONFIG
Description
Number of idle minutes, in the range 1 to 90, the SCS will wait before dropping a connection
to a port. A zero value indicates no time-out. This value is used for any SCS port that has zero
time-out value or no time-out value in its Port Set command.
(To completely disable port time-outs, the time-out value in the Port Set and Server CLI
command must be zero.)
Default = 15 minutes
Description
Indicates that the image loading is either a boot image or an application image
IP address of TFTP server host
Name of file on TFTP server host containing the image file
Description
Reinitializes the SCS but retains the IP address, subnet mask, and gateway
SCS commands 61