Enabling Snmp Processing; Disabling Snmp Processing; Enabling Snmp Traps - HP 16-port SCS Installation Instructions Manual

Defining read, write, and trap community names
Defining and deleting up to four SNMP management entity IP addresses
Enabling and disabling SNMP traps
Defining and deleting up to four trap destination IP addresses
Defining, copying, and deleting up to 10 alert strings for each port
By default, SNMP is enabled, but no traps are enabled and no trap destinations are defined.

Enabling SNMP processing

To enable SNMP processing, issue a Server SNMP command with the Enable parameter. This setting is the
default.
server snmp enable

Disabling SNMP processing

Issue a Server SNMP command with the Disable parameter.
server snmp disable
See "Server SNMP command."
Specifying SNMP community names
Issue a Server SNMP Community command, using the Readcomm, Writecomm, and Trapcomm parameters to
specify community names.
The default community names are "public." If you enable SNMP, change the community values to prevent access to
the Management Information Base (MIB).
server snmp community readcomm=<name> writecomm=<name> trapcomm=<name>
Although all three community names default to public, if you specify a trap community name with this command, it
must be different from the read and write community names.
See "Server SNMP community command."
Adding SNMP management entity addresses
To add an SNMP management entity address, issue a Server SNMP Manager command with the Add parameter
and the IP address of the management entity. You can define up to four SNMP management entity addresses, using
separate commands.
server snmp manager add <ip_address>
When you define at least one SNMP manager, SNMP requests are processed if they are from one of the defined
SNMP managers. If a request is not from one of the defined SNMP managers, the SNMP request is discarded.
Deleting SNMP management entity addresses
To delete an SNMP management entity address, issue a Server SNMP Manager command with the Delete
parameter and the IP address of the management entity.
server snmp manager delete <ip_address>
If no management entities are defined, any SNMP manager can access the MIB. See "Server SNMP manager
command."

Enabling SNMP traps

Issue a Server SNMP Trap command with the Enable parameter.
server snmp trap enable
The SCS displays a numbered list of traps that are currently disabled with a prompt requesting you to select traps to
enable. Indicate the traps to be enabled by entering a trap list number, several numbers separated by commas, a
range of numbers separated by a dash, or a combination of numbers with commas and dashes. To enable all traps,
enter . To cancel the command, press the Enter key.
All
-or-
To enable all SNMP traps, issue a Server SNMP Trap command with the Enable and All parameters. In this
case, the numbered list is not displayed.
Operations 40