Quit; Resume - HP 16-port SCS Installation Instructions Manual

Table 5-11 Port Set command parameters
Parameter
GROUP=<group>
Example
The following command sets a baud rate of 57600 and enables XON/XOFF flow control on port 2.
> port 2 set baud=57600 flow=xonxof
Port Set In/Out
The Port Set In/Out command specifies how carriage returns (CR) and linefeeds (LF) are treated in incoming or
outgoing serial data on one or all ports.
Access right: SCON or PCON
Access level: ADMIN or APPLIANCEADMIN
Syntax:
port [<port>|all] set in|out [cr=<cr>] [lf=<lf>|crlf=cr]
Table 5-12
Port Set In/Out command parameters
Parameter
<port>
ALL
IN|OUT
CR=<cr>
LF=<lf>|CRLF=CR

Quit

The Quit command terminates the current SCS session and terminates your Telnet connection to the unit.
Access right: None needed
Access level: All
Syntax:
quit

Resume

The Resume command exits the CLI and resumes your connection to the attached serial device. The history buffer
contains any data received while you were in CLI mode.
Description
Group name, up to eight characters. Group names are case-sensitive. If the name contains
spaces, enclose the name in double quotes.
If the port was previously assigned to a group and a Port Set command is issued with a
different group specification, the most recent group name is assigned. This is not valid for the
console port.
Description
Port number or name.
Default = Port to which you are attached
Indicates that the port settings that follow should be applied to all ports except the console port.
Either In to specify translation for incoming data or Out to specify translation for outgoing
data.
Translation to be made for carriage returns. Valid values are:
CR=CR—Carriage return is treated as a carriage return.
CR=LF—Carriage return is treated as a linefeed.
CR=STRIP—Carriage return is stripped.
CR=CRLF—Carriage return is treated as a carriage return and linefeed.
Default = CR=CR
Translation to be made for linefeeds. Valid values are:
LF=LF–Linefeed is treated as a linefeed.
LF=CR–Linefeed is treated as a carriage return.
LF=STRIP–Linefeed is stripped.
CRLF=CR–Linefeed is stripped only if it is preceded by a carriage return. This LF setting cannot
be specified with any other LF setting.
Default = LF=LF
SCS commands 58