Mitsubishi Electric GOT2000 Series Connection Manual page 371

Bar code Communication Connection
reader Type cable 1)
*1 RS-422/485 *1
*1 For connectable bar code readers, system equipment, available bar code types and connection cables, refer to the following
Technical News.
➠
List of valid devices applicable for GOT2000 series (GOT-A-0064)
*2 When a GT10-C02H-6PT9P unit of the sub version A or B is used, do not ground the case of the D-sub (9-pin) connector.
*3 GT25-W does not support the option device.
POINT POINT POINT
When using the RS-232 communication unit
Use the RS-232 communication unit of the GOT for connecting to a barcode reader.
However, when the RS-232 communication unit is used, the power cannot be supplied to a bar
code reader from the GOT.
POINT POINT POINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
Connection cable 2)
Option device
- - (Built into GOT)
- GT15-RS4-9S
- GT15-RS4-TE
- - (Built into GOT)
➠
Mitsubishi Products
➠ Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
➠ Microcomputer, MODBUS Products, Peripherals
GOT
PLC
*3
Model
For the system
configuration between
the GOT and PLC,
refer to each chapter.
14.2 System Configuration
Number of
connectable
equipment
1 bar code reader
for 1 GOT
14
14 - 3