GUID-B55423C5-03BB-46A2-9B5F-B8F3B4C854AB
Replacing the touch pad
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
GUID-6784F851-7F54-4023-9C60-EC7EE76A0391
Procedure
NOTE: Ensure that the touch pad is aligned with the guides available on the
palm-rest and keyboard assembly, and the gap on either sides of the touch
pad is equal.
1
Align the screw holes on the touch pad with the screw holes on the palm rest
and keyboard assembly.
2
Replace the screws that secure the touch pad to the palm rest and keyboard
assembly.
3
Adhere the status-light board cable to the touch pad.
4
Align the screw holes on the touch-pad bracket with the screw holes on the
palm rest and keyboard assembly.
5
Replace the screws that secure the touch-pad bracket to the palm rest and
keyboard assembly.
6
Adhere the tape that secures the touch pad to the palm rest and keyboard
assembly.
7
Slide both ends of the touch-pad cable into their respective connectors and
close the latches to secure the cable.
8
Slide the keyboard backlight cable into the connector and close the latch to
secure the cable.
74
computer. After working inside your computer, follow
After working inside your
computer. For more safety best
www.dell.com/
Before