Connecting And Starting Up The Bacnet; Connecting The Bacnet; Setting Tool - Mitsubishi Electric AE-200A Instruction Book

4. Connecting and starting up the BACnet

Tool

4-1. Connecting the BACnet

®
The BACnet Setting Tool communicates with the AE-200 using a LAN.
Before connecting the BACnet
that a cable is not connected to LAN2). Then, connect LAN1 and the PC with the BACnet
using a LAN cable.
®
The BACnet Setting Tool can only be connected to a single AE-200 at a time. Accordingly, when using a
configuration that connects multiple AE-200 units, configure BACnet
• Before configuring the settings of the BACnet
apportioned electricity billing function settings (only when used) with the Initial Setting Tool of the
AE-200 unit.
• When the IP address of AE-200 overlaps the IP address of another machine inside the network, not only
can AE-200 not carry out BACnet
®
BACnet communication normally. Check that the IP address used on AE-200 is configured correctly
before connecting AE-200 to BACnet
• When the settings are changed with the BACnet
mode is changed to [Offline], the monitoring and operation of the AE-200 with the central monitoring
device may become no longer possible and a communication error or other alarm may be detected by
the central monitoring device so contact the system administrator in advance.
WT07921X01
®

Setting Tool

®
Setting Tool to the AE-200, first disconnect the AE-200 from BACnet
®
function, configure the group settings and the
®
communication normally but other devices also cannot carry out
®
.
®
14
®
settings for each AE-200.
Setting Tool, if the AE-200 BACnet
®
Setting
®
(check
®
Setting Tool installed
®
connection