Panasonic KX-T30810 Installation Manual page 104

Extension does not operate.
When speakerphone mode,
is
nothing heard.
The unit does not ring.
During power interruption,
a
extensions 11, 12 and 1 3 do
no t operate.
is
If the system not operating properly, use the Reset
Button.
I!!J Before using Reset Button, try again the system
feature which does not work several times to
confirm there definitely a problem.
liil P ressing the Reset button will cause the fo llowings.
1 . Camp-on to be cleared.
2. Last number redial to be cleared.
3.
Sa ved number redial to be cleared.
4. Calls on hold are terminated.
5.
Calls on exclusive hold are terminated.
6. Calls in progr ess are terminated.
Data that is stored in memory o ther than above
mentioned will not be cleared by use of the Reset
Button.
The Power failure switch of
the KX- T30830 is set to ON.
The HAND SET!
HEAD SET selector of the
KX-T30830 is set the
to
"HEADSET" position.
Ringer Volume Selector is
set to "OFF".
«� The Power failure switch
of th e KX-T30830 is set to
OFF.
®The dialing mode (tone or
pulse) is improper.
•KX-T30820 or
is
KX-T30850 connected.
5-3
Set the Power failure switch to OFF.
When the headset is not used, set the HAND SET/
HEADSET selector to the "HAND SET " position.
Set to "HIGH" or "LOW".
•Set the Power failure switch to 0 N.
® Set the Tone/Pulse switch to the other position.
@Disconnect the KX-T30820 or KX-T30850 and
connect the KX-T30830 or a standard telephmie.
Note
If the system does not operate properly, push th e
Reset Button .
If still no dzf ference occurs, switch the po wer off and
on again after 5 minutes. If the system still does not
work, switch th e po wer o f f
The following extensions will be directly connected
to each of the central office lines (C. O . ) .
Extension 1 1 . . . C. 0 . 1
Extension 12 . . . C. 0.2
Extension 13 . . . C. 0. 3
If the KX-A16 is connected to the system, switch of f
the power of the KX-Al 6.