Panasonic KX-T30810 Installation Manual page 8

Cautions
•A void installing in the following places. (Doing so may result in malfunction, noise, or discoloration.)
1 . In direct sun ligh t and hot, cold, or humid places. (Temperature range: 32°F-1 04oF)
2.
Sulfuric gases produced in areas where there are thermal springs, etc. may damage the equipment or
contacts.
3.
Places in which shocks or vibrations are frequent or strong.
4.
Dusty places, or places where water or oil may come into contact with the unit.
5.
Near high-frequency sewing machines or electric welders.
6.
On or near computers, telexes, or other office equipment, as well as microwave ovens or air conditioners.
(It is preferable not to install in the same room with the above equipment.)
7.
Near radio broadcast antennas (including short wave) .
8.
Install at least 6 feet from radios and televisions. (both the electronic modular switching system and EMSS
proprietary telephones)
9.
Do not obstruct area around the electronic modular switching system. (for reasons of maintenance and
inspection-be especially careful to allo w space for cooling above and at the sides of the electronic modular
switching system)
The wall where the KX-T3081 0 is to be mounted must be able to support a weight of KX- T30810. If screws other
than the ones supplied are used, use the same-sized diameter screws at the enclosed ones.
To Mount on the Wooden Wall:
Place the templet (included) on the wall to mark
1.
the 3 screw positions.
�
t- - --
temp let
..,...
_____
3. Hook the unit on the screw heads.
INSTALLA TION
-+
- - ---- -
2.
Install the 3 screws into the wall.
Drive the screw
to this position.
1-2