Siemens SINUMERIK 810D Configuration Manual page 97

03.02
07.96
12.95
Signal names
INPiξjζ
Signal type
I
Address space
As seen from the PLC, the 810D single I/O module is an S7-300 I/O line compri-
sing the following:
S
S
S
resulting in the following address space:
1. Input range
2. Output range
Each line can only contain one I/O module.
The address space is automatically assigned during start-up. Parameterization
is not necessary.
In AS-PARAM, the 810D I/Os are treated like a corresponding arrangement of
S7-300 modules.
E Siemens AG, 2002. All rights reserved
SINUMERIK 810D Manual Hardware Configuration (PHC) - - 11.02 Edition
27
INP70
29
INP72
31
INP74
33
INP76
Input j of input byte i
Input
P bus interface IM-R
2x 32-bit input module
1x 32-bit output module.
X3 IN
X404
X405
X406
Input byte (line number *32) to (line number *32) +7, i.e. from input byte 32
to input byte 39 during operation in line 1
Output byte (line number *32) +8 to (line number *32) +11, i.e. from output
byte 40 to output byte 44 during operation in line 1
6.1 Single I/O module
I 28
INP71
I 30
INP73
I 32
INP75
I 34
INP77
X3 OUT
32 inputs 0- -31
32 inputs 32- -63
32 inputs 0- -31
6 I/O modules
I
I
I
I
6-95