Vpls Configuration Examples; Static Pw Configuration Example - HP 10500 Series Configuration Manual

Task
Display L2VPN forwarding information (in IRF
mode).
Display MAC address table information for
one or all VSIs.
Display L2VPN PW information.
Display PW class information.
Display Ethernet service instance information.
Display VSI information.
Clear MAC address entries of one or all VSIs.

VPLS configuration examples

Static PW configuration example

Network requirements
Configure VPLS on each PE, and establish static PWs between the PEs to interconnect the CEs.
Figure 74 Network diagram
Configuration procedure
This task includes the following primary configurations:
• Configure basic MPLS on each PE: configure LSR ID, enable LDP, run IGP (OSPF in this example) to
establish LSPs.
Establish static PWs: enable L2VPN, create static PWs, and specify labels.
•
Configure PE 1:
1.
Command
display l2vpn forwarding { ac | pw } [ vsi vsi-name ] [ chassis
chassis-number slot slot-number ] [ verbose ]
display l2vpn mac-address [ vsi vsi-name ] [ dynamic ]
[ count ]
display l2vpn pw [ vsi vsi-name ] [ ldp | static ] [ verbose ]
display l2vpn pw-class [ class-name ]
display l2vpn service-instance [ interface interface-type
interface-number [ service-instance instance-id ] ] [ verbose ]
display l2vpn vsi [ name vsi-name ] [ verbose ]
reset l2vpn mac-address [ vsi vsi-name ]
274