Table of Contents
Advertisement
APPENDIX: RACK MOUNTING THE FT5000
Safety Guidelines
Read through all the safety information and the rack mounting instructions before you start.
Before you remove any cover
Before removing any cover at any time to work inside the system, you should follow these safety
guidelines.
1.
Turn off and disconnect all peripheral devices connected to the system.
2.
Turn off the system by using the push-button on/off power switch on the front of the system.
3.
Unplug the AC power cords from the system or wall outlet.
4.
Use full antistatic precautions as given in the Safety & Regulatory Notices at the front of the
Owner's Handbook.
Tools and supplies needed
Phillips (cross-head) screwdriver (#1 and #2 bit).
Antistatic wrist strap and conductive foam pad (recommended).
Lifting or mechanical handling equipment capable of supporting the maximum configured
weight of the server, (approximately 45 Kg).
Warnings and cautions
These warnings and cautions apply whenever you carry out any work on the system or its
component parts. Only an authorised engineer or other suitably qualified technical person should
attempt to integrate and configure the system.
System power on/off
system AC power. To remove all power from the system, you must unplug the AC power
cords from the wall outlet or the system.
Hazardous conditions, power supply
present inside the power supply. There are no user-serviceable parts inside it.
ESD and handling boards
sensitive to ESD. Hold boards only by their edges. Do not remove boards from their
protective wrapper until you are ready to put it straight into the system.
Cooling and airflow
before turning on the system. Operating it without the cover in place may damage system
components.
Avoid personal injury: To avoid personal injury when unpacking the server, use a mechanical
assist unit to lift it off the shipping pallet. The minimum server configuration weighs 38 kg;
the maximum weighs 45 kg.
: The on/off button on the front panel DOES NOT turn off the
: For proper cooling and airflow, always install the chassis access cover
Do not attempt to lift or move the server by the handles on the power supplies.
Use a hand-truck or other mechanical assist unit to move the server from one location to
another, or to raise it into position for rack mounting.
: Hazardous voltage, current, and energy levels are
: Always handle boards carefully. They can be extremely
FT5000 HANDBOOK
A/1
Advertisement
Table of Contents
