Mitsubishi Electric FT5000 Handbook page 62

C o n f i g u r a t i o n a n d s o f t w a r e u t i l i t i e s
Primary master and slave submenu
In the following table, the features other than "Type" appear only for Type Auto if a drive is
detected.
Feature
Type
Cylinders
Heads
Sectors
Maximum Capacity
Multi-Sector Transfers
LBA Mode Control
32 Bit I/O
Transfer Mode
Ultra DMA
Keyboard features submenu
Feature
Num Lock
Key Click
Keyboard auto-repeat rate
Keyboard auto-repeat delay
7/6 FT5000 HANDBOOK
Choices Description
Auto Auto allows the system to attempt autodetection of the drive type.
None
None informs the system to ignore this drive.
CD-ROM CD-ROM allows the manual entry of fields described below.
IDE Removable User allows the manual entry of all fields described below.
ATAPI Removable
User
1 to 2048 Number of Cylinders on Drive.
This field is changeable only for Type User.
This field is informational only for Type Auto.
1 to 16 Number of read/write heads on drive.
This field is available only for Type User.
This field is informational only for Type Auto.
1 to 64 Number of sectors per track.
This field is available only for Type User.
This field is informational only for Type Auto.
N/A Computed size of drive from cylinders, heads, and sectors entered.
This field is available only for Type User.
This field is informational only for Type Auto.
Disabled Determines the number of sectors per block for multisector
2, 4, 8, or 16 sectors transfers.
This field is informational only for Type Auto.
Disabled Enabling LBA causes logical block addressing to be used in place of
Enabled cylinders, heads, and sectors.
This field is informational only for Type Auto.
Disabled Enabling allows 32-bit IDE data transfers.
Enabled This field is informational only for Type Auto.
Standard Selects the method for moving data to and from the drive.
Fast PIO 1 This field is informational only for Type Auto.
Fast PIO 2
Fast PIO 3
Fast PIO 4
Disabled For use with Ultra DMA drives.
Enabled This field is information only for Type Auto.
Choices
Auto
On
Off
Disabled
Enabled
30, 26.7, 21.8, 18.5, 13.3, 10,
6, or 2 per second
1/4 sec
1/2 sec
3/4 sec
1 sec
Description
Selects poweron state for Num Lock.
Enables or disables key click.
Selects key repeat rate.
Selects delay before key repeat.