Prepare The Slide Assemblies - Mitsubishi Electric FT5000 Handbook

R a c k m o u n t i n g t h e F T 5 0 0 0
11. Use a mechanical assist unit to carefully turn the server onto its left side and remove the
pedestal mountings, as shown in the illustration; each one is held by a single screw.
12. Follow the detailed instructions given on the next pages to fit the rails and install the server
into the equipment rack.

Prepare the slide assemblies

1. Remove the slide assemblies from the kit.
2. Orient a slide assembly so that the smallest outer bar is facing down.
3. Fully extend the telescoping slide assembly until the centre bar hits the safety latch on the
small outer bar (all three overlapping bars will be visible).
A/4 FT5000 HANDBOOK
1
5
1 Large outer bar
2 Centre bar
3 Small inner bar
4 Safety latch on the centre bar
5 Safety latch on the small inner bar
4
2 3