Mitsubishi Electric FT5000 Handbook page 89

Command line format
The basic command line format is
frusdr [-?] [-h] [-d {dmi, fru, sdr}] [-cfg filename.cfg] [-fru filename.fru]
Command
Frusdr
-? or –h
-d {dmi, fru, sdr}
-cfg filename.cfg
-p
-v
Parsing the command line
The FRUSDR load utility allows only one command line function at a time. A command line
function can consist of two parameters. Example: -cfg filename.cfg. Invalid parameters cause an
error message and exit the program. You can use either a slash (/) or a minus sign (-) to specify
command line options. The -p and -v flags can be used in conjunction with any of the other
options.
Displaying usage information
When the utility is run with the -? or -h command line flags, the following message is displayed
when the verbose flag -v is added to the help command:
FRU & SDR Load Utility Version 2.1 Revision R.1.1
Usage: Frusdr
-? or -h
-d {dmi,fru,sdr}
-cfg filename.cfg
-p
-v
Copyright (c) 1998, Intel Corporation, All Rights Reserved
This utility must be run from a system executing DOS. Running in a Window's DOS box is
insufficient and will provide incorrect results. Programming the BMC FRU area clears the SDR
table; therefore the SDR table must be reprogrammed. Upon completing the programming of the
FRU and SDR areas, the server should be rebooted.
N N O O T T E E
DOS users may alternatively use a '/' instead of the '-'.
The following information displays if the -v option is included in the command line.
The /D FRU command may be followed with up to 16 device addresses. These device addresses
are used to view up to 16 different FRU areas, instead of the default of displaying the BMC FRU.
The arguments following the "-d FRU" are in the same order and value as the NVS_TYPE,
NVS_LUN, DEV_BUS and DEV_ADDRESS which are found in the FRU file header in each
FRU file. The LUN address is optional. If the LUN address is used, it must start with an 'L'.
Usage: FRUSDR -d fru (device) [lun] (bus) (addr) (addr2) (etc)
Example: FRUSDR /D FRU IMBDEVICE L00 00 C0 C2
The configuration file may be used to load multiple FRU and SDR files. In the configuration file,
you may define which FRU and SDR areas are to be programmed. Additionally, you may request
information from the user or ask the user to choose which areas to program.
C o n f i g u r a t i o n s o f t w a r e a n d u t i l i t i e s
Description
Is the name of the utility
Displays usage information
Displays requested area only
Uses custom CFG file
Pause between blocks of data
Verbose, display any additional details
Displays usage information
Only displays requested area.
Uses custom CFG file.
Pause between blocks of data.
Verbose, display any additional details.
FT5000 HANDBOOK 7/33