Shelf Supports; Removing The Shelf Supports; Installing The Shelf Supports - AEG BY9314001 User Manual

40 www.aeg.com

12.2 Shelf supports

Removing the shelf supports

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
12.3 Lamp
Before you change the lamp:
• Deactivate the appliance.
DeluxeAppliances - EUappliances.com
When the pyrolytic cleaning
starts, the appliance door is
locked. After the function is com-
pleted, the door stays locked for
the cool down phase. Some of
the appliance functions are not
available during the cool down
phase.
2
1
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
WARNING!
After the function is completed,
the appliance is very hot. Let it
cool down. There is a risk of
burns.
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1. Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.