Hitachi HT-4139-48 Instruction Manual page 26

Paper Setting in the Hopper (Fixed Paper Width)
Wrong examples
Guide of left edge
Paper stack is not aligned to the left
edge.
Paper stack is not straight.
The paper guide is not touched to
paper stack.
Height of paper stack is higher than
the paper guide.
2-4
Paper guide
Hopper Plate
Paper guide
CAUTION
Caution
When setting original manuscript
or removing jammed sheet, be
careful not to cut your finger with
the edge of the sheet.
CAUTION
Caution
Be careful so your watch, bracelet,
cuff, or necktie do not get caught
by a projection or damaged by the
metal part.
① Slide the paper guide about 5 mm
wider than the stack of papers.
② Place the paper stack face up on the
Hopper and align it to the top edge
and left edge to the Paper Guide.
Check if the edge of the papers are
not folded
③ Slide the paper guide and press on
the paper stack slightly.
Hold the Green part of the paper
guide and slide it.
There should be no gaps between the
guides and the paper stack.
④ Select the scan mode on the host and
start scanning.
Do not add papers during scanning.
⑤ Remove the scanned papers from the
stacker.