Power Save Mode; Parameter Setting For Power Save Mode - Hitachi HT-4139-48 Instruction Manual

３ Power Save Mode

3.1 Parameter Setting for Power Save Mode

During power ON and the device is not being used, it can save power consumption as
W
less than 4.75 compared to the regular operation (
/390 W). The mode is default setting at shipment. The transition time to the
power save mode is set 15 minutes.
Setting can be modified as follows.

3. Power Save Mode

HT-4139-28/48:
① Click the "START" button of Windows
"PROGRAM" –> "HT-4139 Image Scanner"
Click the "Low Electric Power Mode (Power
Save Mode) Parameter Setting".
② Click the "OK" button.
③ Select the "Power save mode" and it will be
enabled. To restore the setting, remove the
check mark of the Power Save Mode.
Specify the "Low electric power transition
time" from scan completion to start transition of
1 ~ 60 minutes)
power save mode. (
④ Click the "Execute" button
W
about 280
3-1
３