Figure 1.10 Controller (Eternus Dx100 S4/Dx200 S4) - Fujitsu ETERNUS DX100 S4 Basic Operation Manual

Chapter 1 Component Names and LED Names
1.1 Controller Enclosures

Figure 1.10 Controller (ETERNUS DX100 S4/DX200 S4)

Pattern 1
•
1
13
Pattern 2
•
1
13
1. PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
2. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
3. RMT (LAN) port
This port is used for connecting a LAN cable and used for the remote support function. This port uses an
RJ-45 connector.
4. MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
5. Host interface (CA#0)
Install host interfaces. For details, refer to
6. Host interface (CA#1)
Install host interfaces. For details, refer to
7. IDENTIFY/BBU FAULT LED
8. CA#0 FAULT LED
9. DI (OUT) LINK/FAULT LED
10. READY/FAULT LED
11. CA#1 FAULT LED
12. MASTER LED
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
2
7 11 9 12 10
13 14
6
2 3
7 8 9
13 14 15
5
Copyright 2017 FUJITSU LIMITED
3 4
13 13
14
15 15 5
4
10 11 12
13 13 14
6
"■ Host Interfaces" (page 29).
"■ Host Interfaces" (page 29).
21
8
15
P3AM-7662-09ENZ0