ABB ACH550-01 User Manual page 83

4 Change the values
suggested by the assistant
to your preferences and
then press SAVE after
every change.
Pressing EXIT stops the
assistant.
5 After the assistant has
completed the task, you
can select another
assistant from the menu or
exit the Assistants mode.
The table below lists the tasks of the assistants. The order of
tasks presented by the Start-up assistant depends on your
entries. The following task list is typical.
Task name
Spin the motor
Commission drive
Application
References 1 & 2
Start/Stop Control
Protections
78
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
• Prompts for the control panel display
language selection
• Prompts for motor data
• Guides user through the rotation check
• Prompts for motor data
• Prompts for the application macro selection
• Prompts for the source of speed references 1
and 2
• Prompts for reference limits
• Prompts for frequency (or speed) limits
• Prompts for the source of the start and stop
commands
• Prompts for the start and stop mode
definition
• Prompts for acceleration and deceleration
times
• Prompts for current and torque limits
• Prompts for the use of Run enable and Start
enable signals
• Prompts for the use of the emergency stop
• Prompts for the Fault function selection
• Prompts for the Auto reset functions
selection
ACH550-01 User's Manual
OFF
PAR EDIT
1103 REF1 SELECT
AI1
[1]
EXIT 00:00
OFF ASSISTANTS
Spin the motor
Commission drive
Application
References 1 & 2
Start/Stop Control
EXIT 00:00
Start-up and control panel
SAVE
4
SEL