Parking Sensors (If Equipped) - Suzuki Swift 2015 Owner's Manual

OPERATING YOUR VEHICLE
WARNING
• If the gear is not engaged properly
and completely before the ignition
switch is turned off, the vehicle
may not be parked with the gear
engaged. Always confirm the gear
position by checking the gear posi-
tion indicator when parking.
Remember, even though
transaxle is in gear, you must set
the parking brake firmly.
• On a downhill slope, the gear
should be put in reverse, and in 1st
gear on an uphill slope. In the case
of uphill/downhill slope, after check
the vehicle stopped by the gear
engaged, put chocks under the
wheels. Otherwise, the vehicle may
move, and cause an unexpected
accident. If the gear is left in the
"N" position, the vehicle cannot be
parked with a gear engaged.
Parking cancel
Depress the brake pedal, turn the ignition
switch to the "ON" position, and shift the
gearshift lever to the "N" position. The gear
will be disengaged.
Warning functions
A warning buzzer will sound or the indica-
tor will blink under the following conditions.
3-25
Warning buzzer
• The clutch is heated due to excessive
load.
• The creeping function is being activated
for a long period of time.
NOTICE
In the above cases, pull over to the
side of the road and stop the engine,
the and then ask your MARUTI SUZUKI
dealer to inspect your vehicle. Other-
wise, the clutch disc may be dam-
aged.
• The ignition switch is turned to the
"LOCK" position with the gear in 2nd,
3rd, 4th or 5th. In this case, turn the igni-
tion switch to the "ON" position and shift
the gearshift lever in the "N" position,
shift it to the "D" or "M" or "R" position,
then turn the ignition switch to "LOCK".
• During a stop, the driver's door is
opened with the gearshift lever in the
"R", "D" or "M" position while the engine
is running.
"N" indicator blinking
When the gear indicator lamp blinks "N",
you should depress the brake pedal and
shift the gearshift lever to "N" position.
"1st" indicator blinking
When the gear indicator lamp blinks "1st",
you should depress the brake pedal and
shift the gearshift lever to "N" position, then
shift to "D" or "M" position again a few sec-
onds later.
"R" indicator blinking
When the gear indicator lamp blinks "R",
you should depress the brake pedal and
shift the gearshift lever to "N" position, then
shift to "R" position again a few seconds
later.

Parking Sensors (if equipped)

• The parking sensor system uses ultra-
sonic sensors to detect obstacles near
the rear bumpers. If obstacles are
sensed while you are parking or moving
the vehicle slowly, the system warns you
by sounding a buzzer.
• The system emits an ultrasonic wave
and the relevant sensor detects the
return of the wave reflected by an obsta-
cle. The system measures the time
taken by the ultrasonic wave to reach the
obstacle and return from it, from which it
determines the obstacle's position.
• The parking sensor function can be used
when the ignition switch is turned to the
"ON" or the engine switch is pressed to
change the ignition mode to "ON", the
gearshift lever is in the "R" position and
the parking sensor switch is in the "ON"
position. This function is helpful in the
following cases: pulling over to the curb;
parallel-parking the vehicle; steering the
vehicle into a garage; driving along an
alley; and moving slowly in a place with
obstacles.
74LH0-74E