Table of Contents
Advertisement
Seat Belts and Child Restraint Systems: 3
BEFORE DRIVING
Flashing LED Status
The flashing LED always reflects the status
of the system as following.
SYSTEM CONDITION
LED STATUS
LED does not
Disarmed condition
glow
Slow Flashes
Armed condition
of LED
Intrusion Alert
The system gives a report if it has been
intruded in your absence. Four chirps are
given when UNLOCK button is pressed
after an intrusion.
Diagnostic
Visual-LED
report
Built in Shock
Sensor Trigger
2 Flashes
(full blast warn-
ing)
Door/Trunk/
Tailgate/Engine
3 Flashes
Hood Intrusion
Ignition
5 Flashes
2-15
PROGRAMMABLE FEATURES
System has some features which can be
programmed by user according to their
choice.
Drive Lock Mode
Drive lock mode can be programmed by
SPEED LOCK or can be turned OFF. If
drive lock mode is programmed to SPEED
LOCK, all the vehicle doors will lock when
vehicle attains the speed of 15 Km/hr. If
Drive Lock is programmed to OFF, no door
will lock by speed.
NOTE:
In case of SPEED LOCK Mode, if any door
is open while driving, it will get cancelled.
Once vehicle Speed crosses 15 Km/hr, the
Sound
LED on Security Switch will blink for 5 sec-
onds as indication of door open.
Drive Unlock Mode
Four
Chirps
Drive unlock can be programmed to KEY
or can be turned OFF. When programmed
to KEY, turning Ignition ON to OFF then
removing the key from the key cylinder will
Four
unlock all the doors. If drive unlock is pro-
Chirps
grammed to OFF then no door will unlock
by removing key from key cylinder.
Four
Chirps
Siren Chirp ON/OFF feature
Siren Chirps can be programmed to ON or
OFF. When siren chirp feature disabled,
siren will not chirp after Arm/Disarm by
LOCK/UNLOCK button.
Shock Sensor feature
This is a very important feature of security
system. It enables protection of your vehi-
cle against any major impact. If anybody
tries to intrude into the vehicle, the warning
may trigger. Triggering of the warning is of
two types: pre-warning and full blast warn-
ing. The sensitivity of shock sensor can be
adjusted as desired by the user.
PROCEDURE TO PROGRAM FEATURE
No.
Feature
1 Chirp 2 Chirps Default
Drive Lock
1.
Speed
OFF
Speed
Mode
Drive Unlock
2.
Key
OFF
Key
Mode
Siren chirp
3.
ON
OFF
ON
ON/OFF
Shock Sen-
4.
ON
OFF
ON
sor ON/OFF
Programming Drive Lock Mode
a) Open the Driver Door of your vehicle.
b) With your vehicle key in the Key cylin-
der, turn Ignition ON and then switch it
OFF.
c) Press and release the Security switch
One time.
d) Press and hold the Security switch.
e) One chirp sound confirms entry into
Drive Lock programming mode.
f) Press the Key "Lock" button (while hold-
ing the Security switch), a single chirp
74LH0-74E
Advertisement
Table of Contents
