Engine Bonnet; Sun Visor - Suzuki Swift 2015 Owner's Manual

Engine Bonnet

EXAMPLE
To open the engine hood:
1) Pull the hood release handle located on
the outboard side of the driver's side of
the instrument panel. This will disen-
gage the engine hood lock halfway.
EXAMPLE
74LHT0514
2) Push the under-hood release lever up
with your finger, as shown in the illustra-
tion. While pushing the lever, lift up the
engine hood.
63J063
3) Continue to lift up the hood until it is
high enough to support with the prop
rod.
To close the engine hood:
1) Lift the hood up slightly and remove the
prop rod from the hole. Put the prop rod
back to the holding clip.
2) Lower the hood to about 20 cm above
the hood latch, then let it drop down.
Make sure the hood is securely latched
after closing.
WARNING
Make sure the hood is fully closed
and latched before driving. If it is not,
it can fly up unexpectedly during
driving, obstructing your view and
resulting in an accident.
OTHER CONTROLS AND EQUIPMENT

Sun Visor

EXAMPLE
The sun visors can be pulled down to block
glare coming through the windshield, or
they can be unhooked and turned to the
side to block glare coming through the side
63J065
window.
NOTICE
When unhooking and hooking a sun
visor, be sure to handle it by the hard
plastic parts or the sun visor can be
damaged.
Card holder (if equipped)
(1)
(1) Card holder
You can put a card in the card holder (1) on
the back of the sun visor.
79J161
74LHT0516
5-48
74LH0-74E