NEC Aspila EX Hardware Manual page 137

CÔNG TY VIỄN THÔNG VIỆT PRO
4.
5.
6.
7.
8.
9.
10. Plug the end of the line cord for the analogue device which
11. To determine the APR's analogue extension number . . .
Aspila EX Hardware Manual
Chuyên phân phối tổng đài NEC
If using an APR Adapter, plug the AC-R AC/DC adapter into the AC jack on the side of the
adapter.
The AC/DC adapter is not required when using the APA Adapter.
Position the adapter with the connector positioned as shown below.
Figure 4-28: POSITIONING THE ADAPTER
Hook the two plastic prongs into the bottom of the phone.
Push the connector into place. The top latch on the top of the adapter should lock into place
when it is properly positioned.
Plug the line cord back into the system phone.
Using the ferrite bead that was included with the APA/APR
Adapter, wrap the line cord once through the ferrite bead and
snap it shut.
has the ferrite bead closest to it into the jack on the adapter.
The opposite end should then be connected to the analogue
device.
10-03-06 : PCB Setup
Assign the terminal type (12) for the system phone's channel which has the APR Adapter
installed.
10-03-07 : PCB Setup
The port number of the APR Adapter is displayed for the extension (APR ports = 193-256).
11-02-01 : Extension Numbering
To determine the extension number assigned for the APR device, refer to the table below.
APR Extension Port Number
193
:
199
200
:
256
Section 4: Optional Equipment
Extension Number
493
:
499
5000
:
5056
Section 4: Optional Equipment
http://vietpro.com.vn
4
4-27