Connection To Power Source - Fujitsu IP-900E Hardware User's Manual

Chapter 2 Installation and Connection
2.2.2

Connection to power source

IP-900E/IP-900D/IP-900IID operation requires a power supply of 100-240 VAC. Insert the
power cord with the standard two-prong plug with ground into the inlet connector.
The power cord is not supplied with this equipment. Procure it separately.
Power inlet connector
100-240V
FG
AC cord clamp
Insert the AC cord clamp into the AC cord clamp hole and fix the power cord as shown in
figure above. When remove the AC cord clamp, screw out and remove it with the mounting
kit.
IP-900E/IP-900D/IP-900IID
10/100BASE RS-232C
E
100M
PWR ALM OPT
LINK
RDY IN
/ACT
DWN
MNT
Figure Power cord connection
L R
ANALOG AUDIO IN
Cable holder
36