2.3
Audio and Video Device Connections
2.3
2.3.1
IP-900E (Encoder)
2 Digital and 1analog video input connectors are equipped for connecting with video output equipment.
- SDI Video Input (Digital Video)
Connect to SDI IN connector using BNC cable. Input digital HD-SDI or SD-SDI signal.
The signal is terminated with 75Ω impedance.
- HDMI Input (Digital Video)
Connect to HDMI connector on front panel of IP-900E using the HDMI cable.
Input digital signal of HDMI. The signal is terminated with 50Ω.
- Analog Video Input
Connect to ANALOG VIDEO IN connector using
2 Digital and 1analog audio input connectors are equipped for connecting with audio output equipment.
- Digital Audio Input
SDI Embedded Audio and HDMI audio are supported.
- Analog Audio Input
Connect to ANALOG AUDIO IN
The impedance is 54KΩ unbalanced. Inputting a signal outside of the rated value will cause
a problem in terms of audio level and noise.
The figure of cable connections are shown below.
For details about connectors and cables, see Section 4.2, "Cable and Connector
NOTE:
Details." For electrical specifications, see Appendix 2.3, "Function Specifications."
Figure Audio and video output device connections
(L), (R) using the cable with RCA connector.
100-240V
E
PWR ALM
OPT
IN
RDY
DWN
FG
MNT
39
Chapter 2 Installation and Connection
BNC cable with NTSC or PAL signal.
10/100BASE
RS-232C
L
R
100M
LINK
/ACT
ANALOG AUDIO IN
Video & Audio Output Device
IP-900E/IP-900D/IP-900IID