Connection To Rs-232C Device - Fujitsu IP-900E Hardware User's Manual

Chapter 2 Installation and Connection
2.5
2.5
IP-900E/IP-900D [RS-232C] connector works as communication port. The physical connector of
IP-900E/IP-900D is the D-sub 9 pins (male) and the specification is DTE. Use a cross connection or
straight cable corresponding to the connected device. Refer to Section 4.2, "Cable and Connector
Details" for details.
The figure below shows the connection method.
For details about connectors and cables, see Section 4.2, "Cable and Connector Details."
NOTE:
For electrical specifications, see Appendix 2.3, "Function Specifications."
Figure Connection to RS-232C input/output device
IP-900E/IP-900D/IP-900IID

Connection to RS-232C Device

100-240V
PWR ALM
RDY
FG
10/100BASE RS-232C
E
100M
OPT
LINK
IN
/ACT
DWN
MNT
Data communication
device
42
L R
ANALOG AUDIO IN
D-sub9pin（female）