Closing The Cover Plate Of A Prru Cabling Cavity - Huawei DBS3900 Installation Manual

DBS3900 LampSite
Installation Guide
The connection mode of CPRI_E0 port is the same to that of CPRI_E1 port on pRRU3907, and this chapter
uses CPRI_E0 as an example.
----End
Follow-up Procedure
1.
2.

9.4.9 Closing the Cover Plate of a pRRU Cabling Cavity

This section describes the procedure for closing the cover plate of a pRRU cabling cavity.
Procedure
Step 1 Insert waterproof blocks into vacant cable troughs in the cabling cavity, as shown in
9-23.
onsite requirements.
Ensure that cables and waterproof blocks are properly inserted into troughs.
Figure 9-23 Correct placement of waterproof blocks
Issue 06 (2015-10-30)
NOTE
Route the cable by following the instructions in section
and use cable ties to bind the cable.
Label the installed cable. For details, see section Attaching a Sign Plate Label.
Figure 9-23 is for reference only and vacant cable troughs must be blocked based on
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing a pRRU3907
9.4.1 Cabling Requirements
Figure
160