HP 12500 Series Configuration Manual page 110

[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 12.12.12.1 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 12.12.12.2 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
Configure IP addresses for the interfaces.
3.
# Configure Switch A.
[SwitchA] interface vlan-interface 12
[SwitchA-Vlan-interface12] ip address 12.12.12.1 24
[SwitchA-Vlan-interface12] quit
# Configure Switch B.
[SwitchB] interface vlan-interface 12
[SwitchB-Vlan-interface12] ip address 12.12.12.2 24
Configure the MPLS TE tunnel.
4.
Configure an RSVP-TE tunnel between Switch A and Switch B.
[SwitchA] interface tunnel 1
[SwitchA-Tunnel1] ip address 10.10.10.1 24
[SwitchA-Tunnel1] tunnel-protocol mpls te
[SwitchA-Tunnel1] destination 2.2.2.2
[SwitchA-Tunnel1] mpls te tunnel-id 10
[SwitchA-Tunnel1] mpls te signal-protocol rsvp-te
[SwitchA-Tunnel1] mpls te commit
[SwitchA-Tunnel1] return
Verify the configuration.
5.
On Switch A, display the detailed information about the BFD session between Switch A and Switch
B.
<SwitchA> display bfd session verbose
Total Session Num: 1
Session Working Under Ctrl Mode:
Local Discr: 21
Source IP: 12.12.12.1
Session State: Up
Min Trans Inter: 400ms
Min Recv Inter: 400ms
Running Up for: 00:00:01
Connect Type: Direct
Protocol: RSVP
Diag Info: No Diagnostic
Init Mode: Active
Remote Discr: 20
Destination IP: 12.12.12.2
Interface: Vlan-interface12
Act Trans Inter: 400ms
Act Detect Inter: 2000ms
Auth mode: None
Board Num: 6
102