HP 12500 Series Configuration Manual page 365

Configuring IPv6 IS-IS between MCE and PE
To configure IPv6 IS-IS between MCE and PE:
To do...
Enter system view
Create an IS-IS process for
an IPv6 VPN instance and
enter IS-IS view
Configure a network entity
title
Enable the IPv6 capacity for
the IS-IS process
Redistribute the VPN routes
Configure a filtering policy
to filter the redistributed
routes
Return to system view
Enter interface view
Enable IPv6 for the IS-IS
process on the interface
NOTE:
For more information about IPv6 IS-IS, see
Configuring eBGP between MCE and PE
To configure eBGP between MCE and PE:
To do...
Enter system view
Enter BGP view
Enter IPv6 BGP-VPN instance
view
Configure the PE as the eBGP
peer
Redistribute the VPN routes
Use the command...
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
ipv6 enable
ipv6 import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } export
[ protocol [ process-id ] ]
quit
interface interface-type interface-number
isis ipv6 enable [ process-id ]
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
bgp as-number
ipv6-family vpn-instance vpn-instance-name
peer ipv6-address as-number as-number
import-route protocol [ process-id [ med
med-value | route-policy
route-policy-name ] * ]
357
Remarks
—
Required
Required
Not configured by default.
Required
Disabled by default.
Optional
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.
Optional
By default, IPv6 IS-IS does not filter
redistributed routes.
—
—
Required
Disabled by default.
.
Remarks
—
—
Required
Required
Required
By default, No route
redistribution is configured.