HP 12500 Series Configuration Manual page 298

[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface vlan-interface 2
[PE1-Vlan-interface2] ip address 30.1.1.1 24
[PE1-Vlan-interface2] isis enable 1
[PE1-Vlan-interface2] mpls
[PE1-Vlan-interface2] mpls ldp
[PE1-Vlan-interface2] mpls ldp transport-address interface
[PE1-Vlan-interface2] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
NOTE:
The configurations for PE 2 are similar to those for PE 1. (Details not shown)
After completing the previous configurations, do the following on PE 1 or PE 2:
Execute the display mpls ldp session command to see whether the LDP session has been
established successfully.
Execute the display bgp peer command to see whether a BGP peer relationship has been
established and is in Established state.
Execute the display isis peer command to see whether an IS-IS neighbor relationship has been
set up.
Take PE 1 as an example:
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
----------------------------------------------------------------
4.4.4.9:0
----------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display bgp peer
BGP local router ID : 3.3.3.9
Local AS number : 100
Total number of peers : 1
Peer
4.4.4.9
[PE1] display isis peer
System Id: 0000.0000.0005
LDP Session(s) in Public Network
Status LAM
Operational DU
AS MsgRcvd MsgSent
100 162 145
Peer information for ISIS(1)
----------------------------
290
SsnRole FT MD5
Active Off Off
FT : Fault Tolerance
Peers in established state : 1
OutQ PrefRcv
0 0 02:12:47 Established
KA-Sent/Rcv
378/378
Up/Down State