Configuration Considerations - HP 12500 Series Configuration Manual

Configuration considerations

Enable LDP on the LSRs. LDP dynamically distributes labels and establishes LSPs and thus there is no
•
need to manually configure labels for LSPs.
• LDP uses routing information for label distribution. Therefore, you must configure a routing protocol
to learn routing information. OSPF is used in this example.
Configuration procedure
Configure IP addresses for the interfaces according to
1.
Configure OSPF to ensure IP connectivity between the switches.
2.
# Configure OSPF on Switch A.
<Sysname> system-view
[Sysname] sysname SwitchA
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 11.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure OSPF on Switch B.
<Sysname> system-view
[Sysname] sysname SwitchB
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
# Configure OSPF on Switch C.
<Sysname> system-view
[Sysname] sysname SwitchC
[SwitchC] ospf
[SwitchC-ospf-1] area 0
[SwitchC-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[SwitchC-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] network 21.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] quit
[SwitchC-ospf-1] quit
# Execute the display ip routing-table command on each switch. You will see that each switch has
learned the routes to other switches. Take Switch A as an example:
[SwitchA] display ip routing-table
Routing Tables: Public
Destination/Mask
Destinations : 11
Proto Pre
Figure
Routes : 11
Cost NextHop
35
14. (Details not shown)
Interface