Mpls L2Vpn Configuration Example; Configuring A Martini Mpls L2Vpn Connection Based On Layer 2 Ethernet Interface And Vlan - HP 12500 Series Configuration Manual

To do...
Clear the traffic statistics for a
service instance on an interface

MPLS L2VPN configuration example

NOTE:
By default, Ethernet interfaces, VLAN interfaces, and aggregate interfaces are in DOWN state. To
configure such an interface, first use the undo shutdown command to bring the interface up.
Configuring a Martini MPLS L2VPN connection based on Layer
2 Ethernet interface and VLAN
Network requirements
CEs are connected to PEs through VLAN interfaces.
Establish a Martini MPLS L2VPN connection between CE 1 and CE 2.
Figure 45 Network diagram
Device
CE 1
PE 1
CE 2
Configuration procedure
Configure CE 1.
1.
<Sysname> system-view
[Sysname] sysname CE1
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
Use the command...
reset service-instance statistics [ interface
interface-type interface-number
[ service-instance instance-id [ inbound |
outbound ] ] ]
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Vlan-int10 100.1.1.2/24
Device Interface
P Loop0
Vlan-int20
Vlan-int30
PE 2 Loop0
Vlan-int30
182
Remarks
Available in user view
IP address
192.4.4.4/32
10.1.1.2/24
10.2.2.2/24
192.3.3.3/32
10.2.2.1/24