Unpacking and Installation
Unpacking the Cabinet Assembly
6. Carefully open the rear door (1). Remove the screw holding the rear door support (2) in
place and pull the block out. See Figure 3-3. Then close the rear door.
7. Remove the two (one on each side) shipping clamps from the bottom of the frame. They
are bolted to the pallet, remove the bolt (1) and then remove the clamp (2). See Figure
3-3.
Figure 3-3 Removing Shipping Clamp
8. Remove the pallet shipping block (2) from the rear of the pallet. Remove the two bolts
(1), one on each corner, and pull the block (2) out from under the cabinet. See Figure 3-4.
3-4
Chapter 3