6
System Servicing
This section provides servicing information for the rack-mounted Class D system.
Preparing the System for Servicing
It is strongly recommended that you fully extend the cabinet
WARNING
stabilizer to reduce cabinet instability while servicing the system.
The cabinet may otherwise overturn and cause damage to the
equipment or possible injury.
1. Ensure that all power is disconnected from the system.
2. Remove the front bezel by grasping the detents on either side and pulling the bezel
toward you. Refer to Figure 6-1.
Figure 6-1 Removing the front bezel.
Chapter 6
System Servicing
Preparing the System for Servicing
6-1