System Replacement - HP A1896A Installation Manual

System Replacement

1. Extend the cabinet base assembly fully forward.
2. Position the system onto the base assembly as shown in Figure 6-4, aligning and setting
the system onto the guide pins (callout (1)) in the base plate assembly.
The system weighs as much as 100 lbs and may cause strain if lifted by one
CAUTION
person. Use two people to lift and align the system.
3. Secure the fixed support bracket with the eight screws as shown in callout (2) of Figure
6-3.
4. Secure the pivot support bracket with the three screws as shown in callout (1) of Figure
6-3.
5. Replace the three screws along the rear of the assembly (refer to Figure 6-4).
6. Attach any new (or previously detached) cables to the system.
Attaching the cables while the rails are extended fully forward will ensure
NOTE
sufficient slack for later maintenance.
If the power supply was changed, ensure that the voltage setting of the switch
CAUTION
on the power supply matches the voltage of the cabinet PDU or UPS, if
present.
Chapter 6
System Servicing
Removing the System for Servicing
6-5